TM 55-1520-240-23-7
9-69
REMOVE LANDING LIGHT
(Continued)
9-69
3.
Tilt light (3) and housing assembly (5) to one
side and hold up.
4.
Remove nut (6) and washer (7) from ground stud
(8). Disconnect electrical lead (9).
5.
Lower housing assembly (5). Have helper
support housing assembly so it does not hang.
6.
Remove terminal cover (10).
7.
Remove eight nuts (11) and washers (12). Tag
and remove ten wires (13) from terminal board
(14). Tape wires. Use tape (E385).
8.
Remove housing assembly (5).
9.
Remove gasket (15).
10.
Tag and disconnect seven wires (16) from
terminal board (14).
11.
Cut sealant (17) away from edge of grommet
(18). Use sharp knife.
9-234