TM 55-1520-240-23-7
8-4
INSTALL PILOTS OR COPILOTS EMERGENCY POWER LIGHT
8-4
INITIAL SETUP
Applicable Configurations:
Without 74
Tools:
Electrical Repairers Tool Kit, NSN 5180-00-323-4915
Soldering Gun
Heat Gun
Materials:
Solder (E360)
Tubing (E431)
Personnel Required:
Aircraft Electrician
Inspector
References:
TM 55-1520-240-23P
TM 55-1500-323-25
Remove lens and lamp prior to
soldering. Lamp center contact may
melt and solder in place.
NOTE
Procedure is the same to install pilots
or copilots light. Pilots is shown here.
1.
Remove lens (1) and lamp (2) from light base (3).
2.
Install tubing (4) and solder wires (5) to light base
(3). Slide tubing over solder joint and shrink with
heat gun (TM 55-1500-323-25).
3.
Install light base (3) in panel mount hole (6).
8-22