ASSEMBLE FUEL QUANTITY SWITCH BOX (AVIM)

DISASSEMBLE FUEL QUANTITY SWITCH BOX (AVIM)

ASSEMBLE FUEL QUANTITY SWITCH BOX (AVIM) (Continued)

TM-55-1520-240-23-7 CH-47D Heilcopter Manual
Page Navigation
246

TM 55-1520-240-23-7 8-80.8 ASSEMBLE FUEL QUANTITY SWITCH BOX (AVIM) 8-80.8 INITIAL SETUP Applicable Configurations: All Tools: Electrical Repairer’s Tool Kit, NSN 5180-00-323-4915 Soldering Iron Gun Type Heater Contact/Removal Insertion Tool, M81969/14-03 Materials: Flux (E178) Solder (E360) Tubing Heat Shrinkable (E431) Personnel Required: Aircraft Electrician Inspector References: TM 55-1520-240-23P TM 55-1500-323-24 Equipment Condition: Off Helicopter 1. Position three receptacles (1, 2, and 3) in box assembly (4). Install twelve screws (5), twenty-four washers (6), and twelve nuts (7). 2. Position three relays (8) in cover (9). Install six screws (10), twelve washers (11), and six nuts (12). 3. Connect wires to three relays (8). Refer to tags. Use solder (E360) and tubing (E431) (TM 55-1500-323-24). 4. Connect wires to three receptacles (1, 2, and 3). Refer to tags. Use contact removal/insertion tool (M81969/14-03) (TM 55-1500-323-24). 5. Remove tags. INSPECT 8-256

Privacy Statement
Press Release
Contact