TM 55-1520-240-23-5
6-208.3
INSTALL ENGINE TRANSMISSION CHIP DETECTOR ASSEMBLY
(Continued)
6-208.3
INSTALL CABLE ASSEMBLY
3.
Remove loosely-installed nut (6), washer (7), and
clamp (8) from stud on oil jet (9). Install clamp
on cable (5).
4.
Remove nut (10) from assembly connector (11).
Install connector through bracket (12). Install nut
on connector.
5.
Check that cable (6) is in a smooth curve, with
no kinks or sharp bends. Torque nut (11) to 45
inch-pounds.
6.
Install clamp (8), washer (7), and nut (6) on stud
of oil jet (9). Torque nut to 16 inch-pounds.
7.
Lockwire chip detector valve (1) to temperature
switch adapter (13). Use lockwire (E231).
8.
Connect electrical connector (14) to assembly
connector (11) at bracket (12).
FOLLOW-ON MAINTENANCE:
Perform operational check of chip detector (TM
55-1520-240-T).
Service engine transmission (Task 1-54).
Install engine transmission fairing (Task 4-73).
Install engine air inlet fairing (Task 4-75).
END OF TASK
6-681
