TM 55-1520-240-23-5
6-207
REMOVE ENGINE TRANSMISSION TEMPERATURE AND CHIP DETECTOR
6-207
INITIAL SETUP
Applicable Configurations:
Without 37
Tools:
Aircraft Mechanic’s Tool Kit, NSN 5180-00-323-4692
Torque Wrench, 0 to 150 Inch-Pounds
Container, 1 Gallon
Modified Socket (APP E)
Materials:
Cloths (E120)
Parts:
Preformed Packing
Personnel Required:
Medium Helicopter Repairer
Equipment Condition:
Battery Disconnected (Task 1-39)
Electrical Power Off
Engine Air Inlet Screen Removed (Task 4-65)
Engine Transmission Fairing Removed (Task 4-70)
NOTE
Procedure is same to remove
temperature and chip detector from
left or right engine transmission. Right
transmission is shown here.
1.
Remove lockwire from detector (1) and drain
plug (2).
2.
Remove plug (2) and packing (3). Drain oil. Use
container for oil.
3.
Install plug (2) and packing (3). Torque plug to
90 inch-pounds.
4.
Wipe up any spilled oil with cloths (E120).
5.
Disconnect cable plug (4).
6.
Remove detector (1) and packing (5). Use
modified socket (APP E).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
6-670
