TM 55-1520-240-23-5
6-188
INSTALL COMBINING TRANSMISSION OIL COOLER
(Continued)
6-188
5.
Install oil transfer tube (11) and two packings
(12) in aft left corner of sump cover (3). Install oil
transfer tube (13) and two packings (14) in aft
right comer of sump cover.
NOTE
Do not tilt coolers. Oil can spill.
6.
Install coolers (15 and 16) over cooler (4) and
on two transfer tubes (11 and 13). Press down
firmly to seat coolers on tubes.
7.
Install bolts (17), washers (18) and nuts (19) at
three places around inside of cooler (15). Torque
nuts to 70 inch-pounds.
8.
Install bolts (20), washers (21) and nuts (22) at
six places around outside of cooler (15). Torque
nuts to 70 inch-pounds.
9.
Position clamp (23) against bracket (24). Install
bolt (25) and nut (26).
10.
Connect oil hose (27) to oil pressure transmitter
(28).
Oil (E254) is toxic. It can irritate skin
and cause burns. Avoid inhaling. Use
only with adequate ventilation. Avoid
contact with skin, eyes, or clothing.
In case of contact, immediately flush
skin or eyes for at least 15 minutes.
Get medical attention for eyes.
11.
Coat thread of hose (29) with oil (E254). Connect
hose to reducer (30) on cooler (16).
12.
Coat thread of hose (31) with oil (E254). Connect
hose to elbow (32) on cooler (15).
13.
Install baffle (33) on four studs (34) on sump
cover (3). Install washers (35) and nuts (36).
Torque nuts to 70 inch-pounds.
6-623
