TM 55-1520-240-23-5
6-87
INSTALL GENERATOR DRIVE SHAFT SEAL ON AFT TRANSMISSION
(Continued)
6-87
Dry cleaning solvent (E162) is
flammable and toxic. It can irritate
skin and cause burns. Use only in
well-ventilated area, away from heat
and open flame. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
NOTE
Install generator drive shaft seal on
left or right side of transmission in
same way. Right side shown here.
1.
Clean seal seating area of transmission (1) and
packing groove (2). Use dry cleaning solvent
(E162) and clean cloths (E120). Wear gloves
(E186).
Wear Kevlar gloves when working
around heated area. Hot metal can
burn hands.
Do not heat transmission over 250ºF
(120ºC). Metal can be damaged.
2.
Heat seal seating area (1) to 230º to 250ºF
(110º to 120ºC). Use gun-type heater. Wear
Kevlar gloves (E187). Check temperature with
pyrometer.
6-330
