TM 55-1520-240-23-5
6-84
REMOVE HYDRAULIC PUMP DRIVE SHAFT SEAL FROM AFT
TRANSMISSION
(Continued)
6-84
4.
Cut a piece of lockwire (5) about 24 inches long.
Use lockwire (E232). Wrap ends of lockwire
under heads of two screws (4).
Prying against transmission or drive
shaft will cause damage.
5.
Loop lockwire around a tool (6), such as
screwdriver or wrench extension. Remove seal
(3) by pulling straight out on tool. Do not pry
against transmission or drive shaft.
6.
Remove packing (7) from transmission (8).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
6-323
