TM 55-1520-240-23-5
6-52.1
REPAIR AFT SLIDER SHAFT
(Continued)
6-52.1
8.
Fluorescent inspect the reworked area to check
for cracks (TM 1-1500-335-23). There shall be no
cracks. If a crack is suspected in aft transmission
slider shaft, refer to TM 1-1520-253-23.
9.
Apply surface treatment to the reworked area
as follows:
a.
Clean the area with naphtha (E245) and
clean cloths (E120). Let the area air dry.
Wear gloves (E184.1).
Alodine powder (E65) is an oxidizer.
Discard cloths which contain this
material in a separate container. If
discarded with cloths contaminated
with acetone, MEK, or other organic
solvents, combustion can result. In
case of contact, immediately flush
skin or eyes with water for at least
15 minutes. Get medical attention
for eyes.
b.
Swab solution of alodine powder (E65) in
water on the area. Swab for 2 to 5 minutes.
Use gauze sponges (E184). Wear gloves
(E184.1).
c.
Rinse the area with cold water. Let air dry.
Epoxy primer (E292 and E293) is
flammable and toxic. It can irritate
skin and cause burns. Use only with
adequate ventilation, away from heat
or open flame. Avoid contact with skin,
eyes, or clothing, in case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
d.
If the reworked area is below flange (2), apply
epoxy primer (E292 or E293). Wear gloves
(E184.1).
INSPECT
FOLLOW-ON MAINTENANCE:
None
END OF TASK
6-208
