TM 55-1520-240-23-3
4-102
ADJUST GAS PRODUCER CONTROL SYSTEM
(Continued)
4-102
10.
Adjust resistor shaft (14) one index mark at a
time.
NOTE
Turning resistor shaft clockwise will
cause pointer to move to the right.
Counterclockwise adjustment will
cause pointer to move left.
11.
Set lever (1) to FLIGHT. Wait for NO. 1 ENG
COND light capsule (6) to go out.
12.
Have helper check pointer (2) on fuel control (3).
Make sure index mark (4) on pointer is centered
on MAX band (8). If not, repeat steps 9 thru 11.
13.
Make sure band (10) on rod (9) is partially
covered. If not, do the following:
a.
Cut lockwire and loosen nut (15).
b.
Rotate cylinder (16) until index mark (4) on
pointer (2) is centered on MAX band (8).
c.
Tighten and lockwire nut (15).
4-376
