TM 55-1520-240-23-3
4-60.1
REPLACE ENGINE LOWER ACCESS COVER
(Continued)
4-60.1
INSTALL
5.
Position cover (6) on pylon structure (9). Align
hinge fitting (10) on cover (6) and hinge fitting
(11) on structure. Have helper support cover.
6.
Install hinge pin (7) from forward end of cover (6)
in hinge fittings (10 and 11). Pin must be about
.2 inch inside hinge (10) when fully installed.
7.
Squash end of hinge leave (10) to stop pin (7)
sliding out.
Dry cleaning solvent (E162) is
combustible and toxic. It can irritate
skin and cause burns. Use only with
adequate ventilation, away from open
flame. In case of contact, immediately
flush skin or eyes with water for
at least 15 minutes. Get medical
attention for eyes.
8.
Clean bolt (1) head and surface around bolt hole
(12). Use cloths (E120) and solvent (E162).
Wear gloves (E186).
9.
Position washer (5) and jumper (2) on bolt (1).
Install bolt in hinge (11) and structure (9).
10.
Have helper hold bolt (1). Install washer (4) and
nut (3) on bolt.
Sealant (E339) can irritate skin and
cause burns. Avoid contact with skin,
eyes, or clothing. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
11.
Apply sealant (E339) to bolt (1) head and surface
around bolt. Wear gloves (E186).
FOLLOW-ON MAINTENANCE:
Close engine lower access cover (Task 4-49).
NO BREAK - WORK HARDER
NO BREAK - WORK HARDER
NO BREAK - WORK HARDER
NO BREAK - WORK HARDER
NO BREAK - WORK HARDER
NO BREAK - WORK HARDER
NO BREAK - WORK HARDER
NO BREAK - WORK HARDER
NO BREAK - WORK HARDER
NO BREAK - WORK HARDER
NO BREAK - WORK HARDER
NO BREAK - WORK HARDER
NO BREAK - WORK HARDER
NO BREAK - WORK HARDER
END OF TASK
4-270
