TM 55-1520-240-23-3
3-47
ASSEMBLE LOWER DRAG LINK (AVIM) (Continued)
3-47
WARNING
Wear Kevlar gloves when handling
heated parts. In case of burn,
immediately flush with plenty of water.
Get medical attention immediately.
3.
If a press is not available, heat lower link (2) to
230 to 250 F (110 to 120 C). Use gun type
heater. Monitor temperature. Use temperature
indicating strips (E413). Install bushings (1) in
drag link (2). Use hammer and blunt punch.
4.
Line ream bushings (1) to an inside diameter of
1.876 to 1.877 inches.
5.
Check that measurement of 6.574 to 6.581
inches is maintained between bushings (1).
6.
If instruction plate (3) has been removed, install
on lower link (2) using adhesive (E43).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
3-123
