INSPECT HEATER PARTS (AVIM)

CLEAN HEATER PARTS (AVIM) (Continued) - TM-55-1520-240-23-10_148

INSPECT HEATER PARTS (AVIM) (Continued) - TM-55-1520-240-23-10_150

TM-55-1520-240-23-10 UH-1H/V and EH-1H Aircraft Manual
Page Navigation
119

TM 55-1520-240-23-10 13-5 INSPECT HEATER PARTS (AVIM) 13-5 INITIAL SETUP Applicable Configurations: All Tools: Technical Inspection Tool Kit, NSN 5180-00-323-5114 Ballpeen Hammer Compressed Air Source Water Tank Materials: Acetone (E20) Methyl-Ethyl-Ketone (E244) Gloves (E186) Personnel Required: Medium Helicopter Repairer Inspector References: TM 55-1520-240-23P TM 1-1500-204-23 Equipment Condition: Off Helicopter Task Heater Parts Cleaned (Task 13-4) Acetone (E20) can form toxic vapors if exposed to flame. Methyl-ethyl-ketone (E244) is flammable and toxic. It can irritate skin and cause burns. Use methyl-ethyl-ketone and acetone in well-ventilated areas, away from heat and open flames. In case of contact, immediately flush skin or eyes with water for at least 15 minutes. Get medical attention for eyes. 1. Check inside of igniter plug well (1) for signs of arcing or carbon tracks. If arcing or carbon tracks are found, clean igniter plug (2) with acetone (E20) or methyl-ethyl-ketone (E244). Wear gloves (E186). 2. Check porcelain on igniter plug (2). There shall be no cracks, breaks, or pitting. 13-25

Privacy Statement
Press Release
Contact