TM 55-1520-240-23-1
1-32
INSTALL PROTECTIVE COVERS
(Continued)
1-32
1.
Install cockpit enclosure protective cover (T103)
(1) as follows:
a.
Position cover (1) on helicopter. Fit cover
over raised areas (2). Use tabs (3) to adjust
cover position.
b.
Hook fasteners (4) on four top ropes (5)
together behind fairing (6). Tighten ropes.
Use four sliding fasteners (7).
c.
Hook fasteners (4) on four bottom ropes (8)
to landing gear tiedown fittings (9).
d.
Tighten bottom ropes (8). Use sliding
fasteners (7).
e.
Secure flap (10) between pitot tubes (11).
Use two snap fasteners and hook-and-pile
tape.
2.
Install heater exhaust protective cover (T21) as
follows:
a.
Insert plug (12) into heater exhaust (13).
b.
Prevent handle (14) from turning.
c.
Tighten wing nut (15) to expand plug (12).
3.
Position cover (T59) (16) on heater inlet (17).
Secure four fasteners (18).
1-112