• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL  AFT  FUSELAGE  BELLCRANK  (FORWARD  SIDE  STATION  482 BULKHEAD) (Continued) - TM-55-1520-240-23-9_983
REMOVE  AFT BELLCRANK  STA  482

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  950    951    952    953    954  955  956    957    958    959    960  
TM  55-1520-240-23-9 11-249 INSTALL  AFT  FUSELAGE  BELLCRANK  (FORWARD  SIDE  STATION  482 BULKHEAD) (Continued) 11-249 13. Remove  nut  (23),  two  washers  (24  and  25),  and bolt  (26)  from  bellcrank  (5). 14. Untie  link  (27)  and  position  link  in  bellcrank  (5). Install  bolt  (26),  two  washers  (25  and  24),  and nut  (23). 15. Torque  nut  (23)  to  60 to 90  inch-pounds.  Install cotter  pin  (28). 16. Check  three  bolts  (4,  20,  and  26).  Bolts  shall  not rotate  with  a  torque  less  than  10  inch-pounds torque.  There  shall be  no  axial  looseness.  If  bolt rotates  or  is  loose,  add  AN960  washer  under  nut, and  repeat  step  9,  12,  or  16.   If  an  AN960  light washer  is  used,  prior  to  torquing,  make  sure  that the  washer  does  not  hang  up  in  the  bolt  retaining feature  groove. NOTE If  connecting  links  are  changed  in length,  perform  neutral  rig  check (Task  11-33). INSPECT FOLLOW-ON  MAINTENANCE: Connect  servocylinder  connecting  links  (Task 11-193). Remove  safety  blocks  (Task  11-29). Close  pylon  doors  (Task  2-2). END  OF  TASK 11-968







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.