• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
REMOVE  FIRST STAGE  MIXING  ASSEMBLY (Continued) - TM-55-1520-240-23-9_765
REMOVE  FIRST STAGE  MIXING  ASSEMBLY (Continued) - TM-55-1520-240-23-9_767

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  737    738    739    740    741  742  743    744    745    746    747  
TM  55-1520-240-23-9 11-188 REMOVE  FIRST STAGE  MIXING  ASSEMBLY (Continued) 11-188 17. Tag  bellcrank  (11).   Remove  cotter  pin  (65), nut  (66),  washers  (67),  and  bolt  (68).  Remove bellcrank (11).   Install  bolt,  washers  and  nut  in bellcrank  (33). 18. Tag  bellcrank  (22),  Remove  cotter pin  (69  nut (70),  washers  (71),  and  bolt  (72).   Remove bellcrank (22).   Install  bolt,  washers,  and  nut  in bellcrank  (44). TO REMOVE THRUST, YAW, PITCH INPUT AND ROLL INPUT  BELLCRANKS 19. Have  helper, in  passageway,  stop  shaft (74) from turning,  using  rod  (73) (or  spanner  wrench)  in slotted  end  of  shaft  as  shown. 20. Remove  cotter pin  (75), nut (76), and  spacer (77) from  shaft (74).  Use  2-1/8  inch  socket.  Remove rod  (73)  from  shaft. 21. Tap  threaded  end  of  shaft  (74) until  end  of  shaft is  flush  with  bulkhead  (78).   Use  plastic  faced hammer. 22. Tag  roll  input  bellcrank  (17), yaw bellcrank  (44), and  thrust  bellcrank  (33).  Have  helper  on  work platform  support  bellcranks  (33  and  44). Do  not drive  shaft  out  of  bellcranks. Damage  to  bellcranks and  bearings will  result. 23. Carefully  slide  shaft  (74)  inboard  until  bellcrank (17)  is released.  Remove  bellcrank. 11-750







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.