TM 55-1520-240-23-9
11-160
DISASSEMBLE PITCH CCD ACTUATOR (AVIM)
(Continued)
11-160
16.
Tag and unsolder 5 wires (36) from lug (30).
17.
Loosen screw (37) of clamp (38). Remove motor
(39) and clamp. Pull outward.
18.
Mark position of output arm (45) and stop plate
(47) on chassis (7). Use masking tape (E388)
and pencil (E271).
19.
Remove nut (42), washers (43), and bolt (44)
from arm (45). Slide arm from shaft (46).
20.
Slide plate (47) and shim (48) from shaft (46).
FOLLOW-ON MAINTENANCE:
Inspect trim motor (Task 11-156).
END OF TASK
11-653
