• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL  ROLL MAGNETIC  BRAKE
REMOVE  THRUST  CCD  ACTUATOR

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  622    623    624    625    626  627  628    629    630    631    632  
TM  55-1520-240-23-9 11-153 INSTALL ROLL MAGNETIC BRAKE (Continued) 11-153 Make  sure  bushings  are  in  arm  before installing  bolt or component  damage will  result. NOTE Impedance  bolts  are  installed  in  flight control  connections.  These  bolts are self-retaining  and  require  a  special nut and  torque  (Task  1-13). 1. If  roll  magnetic  brake  (1)  is  a  replacement, perform  rigging  check  (Task 11-49). FLIGHT  SAFETY  PARTS This  is  an  installation  critical  flight safety part.  All aspects of its assembly and  installation  must  be  ensured  at each  joint  connection  including  its mounting  to  the  pallet  assembly. Ensure  mag  brake  output  arm  is properly  positioned  and  secured  to the  output shaft of the  actuator. Ensure  proper  torque  values  are utilized  when  instaling  brake  to  pallet mounting  hardware. Ensure  proper attaching  hardware (self  retaining  type  bolt,  nut,  and washers)  is  installed  including verification  of  bolt head  orientation, torque, and  installation  of  cotter pins. Loose  attachments within  flight control primary  linkage  will  degrade  aircraft control.   Missing  components  will cause  loss of  control. 2. Position  brake  (1)  on  pallet  (2), arm (3) outboard, receptacle  (4)  down.   Install  four  bolts  (5)  and washers  (6).  Torque  bolts to  45 inch-pounds. 3. Position  spring  (7) in  arm (3).  Install  bolt (8), two washers  (9  and  10) and  nut  (11). 4. Torque nut (11) to  30 inch-pounds.  If necessary, continue  tightening  to  align  cotter  pin  holes.  Do not  exceed  45  inch-pounds.   Install  cotter  pin (12). 5. Connect connector (13) to  receptacle  (4) of brake (1).  Remove  tag  from  connector. 6. Check  bolt (8).  Bolt  shall not  rotate  with  torque less than  10 inch-pounds.   There  shall  be  no axial  looseness.  If  bolt rotates  or is  loose,  add washer under nut and  repeat step  4. INSPECT FOLLOW-ON MAINTENANCE: Perform  pallet  roll controls  rig  check (Task 11-49). Perform  operational  check  of  flight  controls  (TM 55-1520-240-T). Install  closet backup  panel  (Task 2-2). Install  closet acoustic  blanket (Task  2-108). END  OF  TASK 11-633







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.