• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
REMOVE  ROLL IDLER BELLCRANK
REMOVE  ROLL IDLER  BELLCRANK (Continued) - TM-55-1520-240-23-9_527

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  499    500    501    502    503  504  505    506    507    508    509  
TM  55-1520-240-23-9 11-97 REMOVE  ROLL IDLER  BELLCRANK (Continued) 11-97 NOTE If  a  crack  in  the  connecting  link, bellcrank,  or support is  suspected during  removal,  refer  to  TM 1-1520-253-23. NOTE Attaching  bolts, washers, and  nuts  will be  temporarily installed  after removing links  and  bellcrank. 1. Mark  position  of bolt  (1)  in  spring  support  (2). Use  pencil  (E271). 2. Tag  spring  support  (2).  Remove  cotter  pin  (3), nut  (4),  and  washer (5)  from  bolt  (1).   Push support  (2) down.  Remove  bolt  (1) and  washer (6).   Disconnect support  and  tie  support  away from  bellcrank  (7).  Use  twine  (E433). 3. Install  bolt (1),  two  washers (5  and  6) and  nut  (4) loosely  in  bellcrank  (7). 4. Tag  magnetic brake  connecting  link  (8).  Remove cotter  pin  (9),  nut  (10),  two  washers  (11),  and bolt  (12) from  bellcrank  (7).  Disconnect  link  and tie  link  away  from  bellcrank.  Use  twine  (E433). 5. Install  bolt (12),  two  washers  (11), and  nut  (10) loosely  in  bellcrank  (7). 6. Tag  spring  assembly  (13).   Remove  cotter  pin (14),  nut  (15),  two  washers  (16),  and  bolt  (17) from  bellcrank (7).   Disconnect  spring  and  tie spring  away from  bellcrank.  Use  twine  (E433). 7. Install  bolt (17),  two  washers  (16), and  nut  (15) loosely  in  bellcrank  (7). 11-510







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.