• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL  PALLET THRUST IDLER  BELLCRANK (Continued) - TM-55-1520-240-23-9_522
INSTALL  PALLET THRUST IDLER  BELLCRANK (Continued) - TM-55-1520-240-23-9_524

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  496    497    498    499    500  501  502    503    504    505    506  
TM  55-1520-240-23-9 11-96 INSTALL PALLET THRUST IDLER  BELLCRANK (Continued) 11-96 2. On  helicopters  with    74  ,  perform  the  following steps: a. Install nut (1) and  washer  (2)  on  bolt (3) about mid-position. b. Insert  bolt  (3)  in  arm  (4)  of  thrust  idler bellcrank  (5).   Install  washer  (6)  and  nut (7) on  bolt  (3).  Do  not  torque  nut  at  this time. c. Remove  two  nuts  (8  and  9),  four  washers (10,  11, 12,  and  13),  and  two  bolts (14  and 15)  from  support  (47). d. Remove  slipfit bushings (16).  Clean  bushings (16),  bores,  and  inside  diameter  of  bushing (48)  with  dry  cleaning  solvent  (E162)  and clean  cloths (E120).  Wear  gloves  (E184.1). e. Coat  bushings  (16)  with  epoxy  primer (E292.1).  Install  bushings (16)  wet  in  support (47).   Wear  gloves (E184.1). f. Position  bellcrank  (5)  in  support  (47),  arm (4)  up  and  forward.   Install  bolt  (14),  two washers (11  and  10), and  nut  (8)  in  support (47),  outboard  end. g. Install  bolt  (15),  two  washers (12  and  13), and  nut  (9)  in  support (47), inboard  end. h. Torque  two  nuts  (8  and  9)  to  30  to  45 inch-pounds.  Install  two  cotter  pins (17  and 18). i. Check  bolts  (14  and  15).   Bolts  shall  not rotate  with  torque  less than  10 inch-pounds. There  shall  be  no  axial  looseness.   If  bolt rotates  or  is loose,  add  washer  under  nut, and  repeat  step  h. INSPECT 11-507







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.