• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL CONTROL  PALLET STA  95 (Continued) - TM-55-1520-240-23-9_506
INSTALL CONTROL  PALLET STA  95 (Continued) - TM-55-1520-240-23-9_508

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  480    481    482    483    484  485  486    487    488    489    490  
TM  55-1520-240-23-9 11-92 INSTALL CONTROL PALLET  STA  120 11-92 INITIAL  SETUP Applicable Configurations: All Tools: Aircraft  Mechanic’s Tool  Kit, NSN  5180-00-323-4692 Torque  Wrench,  30  to  150  Inch-Pounds Transfer  Bellcrank  Rig  Pin  (T128) Pitch  and  Roll  Pallet Rig  Pin  (T134) Materials: None Parts: Cotter  Pins Personnel  Required: Medium  Helicopter  Repairer  (2) Inspector References: TM  55-1520-240-23P Do  not  install  bolts  unless  bushings are  in  bellcranks;  otherwise, damage to  bellcranks  will  result. NOTE Impedance  bolts  are  installed  in  flight control  connections.   These  bolts are  self-retaining  and  require  special torque  and  nut (Task  1-13). 1. Position  control  pallet  (1)  inside  closet  (2)  on bulkhead  (3),  with  CCDA (4)  up  and  forward. NOTE Longer  bolts  are  installed  outboard, shorter  bolts inboard. 2. Have  helper  support pallet  (1).  Working  in  cabin, install  eight  washers  (5)  and  bolts  (6)  through bulkhead  (3)  and  in  pallet.   Torque  bolts from  50 to 60 inch-pounds. 11-491







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.