TM 55-1520-240-23-9
11-86
INSTALL COCKPIT CONTROL TRANSFER CONNECTING LINKS
(Continued)
11-86
30.
Clean sealant from flange (69) and inside surface
(70) of access (20). Use acetone (E20) and
cloths (E120). Wear gloves (E186) and goggles.
Wires must not support housing;
otherwise, damage to equipment
could occur.
31.
Support landing light housing (71). Remove
strap (72).
Sealant (E336) can irritate skin and
cause burns. Avoid contact with skin,
eyes, and clothing. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
32.
Apply sealant (E336) to both sides of gasket (73).
Install gasket on flange (69). Remove excess
sealant with acetone (E20) and cloths (E120).
Wear gloves (E186) and goggles.
33.
Tilt housing (71) and position inside access (20),
lamp (74) aft. Align housing and access holes
(75).
11-458