• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
RIG  PITCH  OVERTRAVEL STOP (Continued) - TM-55-1520-240-23-9_207
RIG  COCKPIT  TRANSFER BELLCRANKS

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  185    186    187    188    189  190  191    192    193    194    195  
TM  55-1520-240-23-9 11-45 RIG PITCH CONTROL POSITION  INDICATOR 11-45 INITIAL  SETUP Applicable  Configurations: All Tools: Aircraft  Mechanic’s  Tool  Kit,  NSN  5180-00-323-4692 Materials: Lockwire  (E231) Personnel  Required: Medium  Helicopter  Repairer Inspector Equipment  Condition: Battery  Disconnected  (Task  1-39) Electrical  Power  On Hydraulic  Power  On Pilot’s  Seat  Full  Aft  (Task  2-115) Pilot’s  Rigging  Fixture  Installed  (Task  11-22) Pilot’s  Control  Stick  Yoke  Installed  (Task  11-22) 1. Remove  lockwire  from  adjuster  (1). Do  not  kink  or  deform  tubing  or  cable; otherwise,  damage  to  component  will result. 2. Loosen  three  screws  (2)  of  clamps  (3). 3. Loosen  two  nuts  (4)  of  adjuster  (1). 4. Turn  adjuster  (1)  until  pitch  control  position indicator  (5)  is  one  division  forward  of  N. 5. Check  inspection  holes  (6)  of  adjuster  (1). Thread  of  nuts  (4)  must  show  in  holes. 6. Tighten  two  nuts  (4)  of  adjuster  (1). 7. Tighten  three  screws  (2)  of  clamps  (3). 8. Lockwire  two  fittings  (7)  and  adjuster  (1).   Use lockwire  (E231). FOLLOW-ON  MAINTENANCE: Remove  pilot’s  control  stick  yoke  (Task  11-23). Remove  pilot’s  rigging  fixture  (Task  11-23). END  OF  TASK 11-192







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.