TM 55-1520-240-23-9
11-42
RIG COCKPIT CONTROL ASSEMBLIES
(Continued)
11-42
62.
Hold yoke (27) of pilots fixture (6). Remove pin
(30). Lower yoke fully in fixture.
63.
Position yoke (27) 90º to control stick (31).
64.
Check position of stick (31) forward or aft, then
right or left. Measure distance between yoke
(27) and stick. Distance must not be more than
0.06 inch. If distance is not more go to step 65.
If distance is more repeat steps 25 thru 41 then
steps 62 thru 64.
65.
Check position of pilots control (73). Measure
distance Y between pivot block (74) and grip
(75). Record distance.
66.
Remove pin (63) from pilots support (65).
67.
Repeat step 65. Distance must not be more than
0.06 inch up or down from distance measured
in step 65. If distance is not more go to step 68.
If distance is more repeat steps 46 thru 57 then
steps 65 thru 67.
11-173