TM 55-1520-240-23-9
11-271
ASSEMBLE AFCS CONTROL PANEL (AVIM)
(Continued)
11-271
19.
Position four support rods (34) on front mount
panel (15) and install four screws (35). Use
sealant (E345) on screws.
NOTE
Procedure to install three toggle
switches is the same. CYCLIC TRIM
AUTO/MAN switch is shown here.
20.
Position switch (36) in panel (15). Install washer
(37) and nut (38).
21.
Connect 12 wires (39) to switch (36) using
washers (40) and screws (41).
22.
Position front illumination panel (42) on front
mount panel (15). Make sure lamp receptacle
connector (14) and illumination panel plug (43)
snap together.
23.
Install three screws (44). Use sealant (E345)
on screws.
24.
Position knob (45) on switch shaft (46) and
tighten two set screws (47).
11-1031