TM 55-1520-240-23-9
11-271
ASSEMBLE AFCS CONTROL PANEL (AVIM)
(Continued)
11-271
7.
Install receptacle connector (14) in front
mounting plate (15).
8.
Install ground lug (16), washer (17) and nut (18).
8.1.
Solder wire (18.1) to receptacle connector (14).
Be careful when removing lamp
carrier. Lamp carrier is attached
to pushbutton switch by a sliding
retainer. Retainer can be damaged by
excessive force. Pull lamp carrier out
only enough to rotate down.
NOTE
Installation of three pushbutton
switches is the same. RAD ALT
ENGAGE switch is shown here.
9.
Pull lamp carrier (19) out and down.
10.
Remove tag. Install pushbutton switch (20) in
front mount panel (15) with TOP up.
11.
Install adapter sleeve (21) and retainer sleeve
(22) onto back of pushbutton switch (20).
12.
Tighten two screws (23) inside pushbutton switch
(20). Tabs (24) must turn out away from switch
and pull sleeves (21 and 22) against mounting
plate (15).
11-1029