REPAIR FUEL CELL INTERIOR PLIES
Carefully apply a uniform coat of repair
cement (10) over patched area to within no
more than 1/8 inch of O.D. of buffed edge.
Smooth surface with gloved fingers wet with
MEK (E244). Use a brush. Remove any
excess cement with cloths (E120) dampened
with MEK (E244). Wear gloves (E184.1).
Do not flex fuel cell in repair area.
Allow finished repair to set for 1 hour before
moving fuel cell.
Allow finished repair to air cure for 24 hours
Visually inspect repair for workmanship, no loose
edges, no voids, cement fully cured.
END OF TASK