TM 55-1520-240-23-8
10-60
INSTALL FUEL LEVEL CONTROL VALVE AND MOUNTING BRACKET IN MAIN FUEL
TANKS
(Continued)
10-60
Dry cleaning solvent (E162) is
flammable and toxic. It can irritate
skin and cause burns. Use only in
well-ventilated area, away from heat
and open flame. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
Do not use main tank fuel level
control valves in auxiliary tanks or
auxiliary tank valves in main tanks.
Fuel system will not operate properly
unless correct valves are used in
correct tanks.
NOTE
Procedure is same to install fuel level
control valve and mounting bracket in
either main fuel tank. Installation of
valve and bracket for No. 1 (left) tank
is shown here.
1.
Remove barrier material and tape from access
hole (1) in tank. Remove tape residue from
tank. Use dry cleaning solvent (E162) and cloths
(E135). Wear goggles to protect eyes. Wear
gloves (E186).
10-302