MAIN TANK (NO. 2 SYSTEM) FUEL LEVEL SHUTOFF VALVE INSTALLATION
Position tube (1) against valve (2). Install four
bolts (3), washers (4), and nuts (5).
Install packing (6) on fitting (7). Position fitting
against valve (2). Install four bolts (8) and
Install packing (10) on mounting flange of valve
Dry cleaning solvent (E162) is
flammable and toxic. It can irritate
skin and cause burns. Use only in
well-ventilated area, away from heat
and open flame. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
Remove barrier material and tape from the
opening in tank (11). Clean tape residue from
tank with dry cleaning solvent (E162) and cloths
(E120). Wear goggles to protect eyes. Wear
Pull the ends of hoses (12) through the opening
to the outside of tank (11). Maneuver valve (2)
into position next to the tank opening. Connect
the hoses to the valve. Remove tags.
Position valve (2) against the face of tank (11).
Install 10 bolts (13) and washers (14).