REPAIR OVERHEAD PANELS
The lightplate on all panels is replaced
in the same manner. TROOP
WARN/HEATING panel shown here.
Remove lightplate (12) as follows:
If installed, remove knobs (13) by loosening
setscrew (14). Unscrew lamps (15).
White cross on face of lightplate
indicates location of electrical plug.
Loosen captive screws (16). Carefully
pull lightplate (12) away from panel (8) to
separate lightplate from connector (17)
behind white cross (18).
Install lightplate (12) as follows:
Align cross (18) on lightplate with connector
(17). Push plug behind cross into connector.
Press on cross to ensure plug is seated.
Tighten captive screws (16).
If applicable, install knobs (13). Tighten knob
setscrew (14). Install lamps (15).