TM 55-1520-240-23-7
9-91
INSTALL ANTICOLLISION LIGHT
9-91
INITIAL SETUP
Applicable Configurations:
All
Tools:
Electrical Repairers Tool Kit, NSN 5180-00-323-4915
Heat Gun
Workstand
Materials:
Acetone (E20)
Cloths (E120)
Sealant (E336)
Shrinkable Tubing (E431)
Gloves (E186)
Lockwire (E231)
Personnel Required:
Aircraft Electrician
Inspector
References:
TM 55-1520-240-23P
NOTE
Procedure is similar for installing top
or bottom light, except where noted.
Installation of bottom light is shown
here.
1.
Install shrinkable tubing (2) 3 inches long to
extend two vent studs (3). Use shrinkable tubing
(E431).
2.
Shrink tubing (2) when it contacts vent (4). Use
heat gun.
9-298