• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL  NO.  1 OR NO.  2 PITOT TUBE (Continued)
REMOVE  SIDESLIP SENSING  PORTS (Continued)

TM-55-1520-240-23-7 CH-47D Heilcopter Manual
Page Navigation
  95    96    97    98    99  100  101    102    103    104    105  
TM  55-1520-240-23-7 8-31 REMOVE  SIDESLIP  SENSING PORTS 8-31 INITIAL  SETUP Applicable Configurations: All Tools: Electrical  Repairer’s Tool Kit, NSN 5180-00-323-4915 Workstand Materials: None Personnel  Required: Aircraft  Electrician Equipment  Condition: Battery Disconnected  (Task  1-39) Electrical  Power Off Hydraulic  Power Off Nose  Enclosure  Access  Door Open  (Task 2-2) NOTE Procedure  is  the  same  to  remove  all four sideslip  sensing  ports.  No.  1  RH is  shown  here. 1. Disconnect electrical  connector (1) from  sideslip sensing  port  (2). Do  not  disassemble  compression fitting  in  order to  retain  clips  inside  of compression  fitting. 2. Disconnect  sideslip  sensing  line  (3),  at compression  fitting  nut (4). 3. Remove  six  screws (5). 4. Remove  sideslip  sensing  port (2)  from  window panel  (6). 8-107







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.