• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL NO.  1  OR  NO. 2  PITOT TUBE
REMOVE  SIDESLIP  SENSING PORTS

TM-55-1520-240-23-7 CH-47D Heilcopter Manual
Page Navigation
  94    95    96    97    98  99  100    101    102    103    104  
TM  55-1520-240-23-7 8-30 INSTALL  NO.  1 OR NO.  2 PITOT TUBE (Continued) 8-30 2. Connect  pitot  line  (4)  to  pitot  tube  fitting  (3). Make  sure  word  "TOP" (5)  is  at  up  position  and that  drain  hole  (6)  is down. 3. Connect  electrical  connector  (7)  to  pins  (8). 4. Slide  sleeve  (2)  over  pitot  tube  (1)  and  into  pitot tube  support  (9). 5. Install  four  screws (10)  and  washers (11). 6. Install  three  screws  (12)  and  washers (13).  Make sure  word  "TOP"  (5)  is  at  up  position  and  that drain  hole  (6)  is down. Sealant  (E336)  can  irritate  skin  and cause  burns.  Avoid  contact  with  skin, eyes,  or  clothing.  In  case  of  contact, immediately  flush  skin  or  eyes  with water  for  at  least  15 minutes.   Get medical  attention  for  eyes. 7. Seal  screws  (10)  and  pitot  tube  (9)  mating surfaces. INSPECT FOLLOW-ON  MAINTENANCE: Test  pitot-static system  (TM  55-1520-240-T). Close  nose  enclosure  access door  (Task 2-2). END  OF  TASK 8-106







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.