• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL NO.  1  OR  NO.  2 PITOT  TUBE  SUPPORT
INSTALL NO.  1  OR  NO. 2  PITOT TUBE

TM-55-1520-240-23-7 CH-47D Heilcopter Manual
Page Navigation
  92    93    94    95    96  97  98    99    100    101    102  
TM  55-1520-240-23-7 8-29 INSTALL  NO.  1 OR  NO.  2 PITOT TUBE  SUPPORT (Continued) 8-29 5. Position  pitot  tube  support  (7),  over  pitot  line (4)  and  wire  harness  connector  (2).  Use  twine (E433)  to  tie  connector  (2)  to  pitot  tube  end  of line. 6. Install  four  screws  (8).  Make  sure  seal washers (9)  are  under  heads  of  screws. 7. Install  four  washers  (10)  and  nuts  (11). 8. Remove  twine  installed  in  step  5. Sealant  (E336)  can  irritate  skin  and cause  burns.  Avoid  contact  with  skin, eyes,  or  clothing.  In  case  of  contact, immediately  flush  skin  or  eyes  with water  for  at  least  15 minutes.   Get medical  attention  for  eyes. 9. Seal  screws  (8)  and  pitot  tube  support  (7)  mating surfaces.   Use  sealant  (E336). INSPECT FOLLOW-ON  MAINTENANCE: Install  pitot  tube  (Task  8-30). Close  nose  access  door  (Task  2-2). END  OF  TASK 8-104







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.