TM 55-1520-240-23-7
9-164.5
ASSEMBLE FUEL PRE-CHECK PANEL
(Continued)
9-164.5
INSTALL DIODE
NOTE
Procedure is similar to install eight
diodes.
11.
Connect diode (23) to terminals (24). Observe
polarity. Use heat sink. Use solder (E319).
12.
Remove tags.
INSTALL INDICATOR LIGHT
NOTE
Procedure is same to install three
indicator lights. Installation of LH
REFUEL VALVE light is shown here.
13.
Install lampholder (25), washer (26), and nut
(27). Install lens cap (28).
14.
Connect three wires (29) by installing two screws
(30) and washers (31).
9-664