TM 55-1520-240-23-6
7-233
INSPECT BRAKE TRANSFER VALVE (AVIM)
7-233
INITIAL SETUP
Applicable Configurations:
All
Tools:
Technical Inspection Tool Kit, NSN 5180-00-323-5114
Torque Wrench, 0 to 15 Inch-Ounces
Torque Wrench, 5 to 50 Inch-Pounds
Outside Micrometer Caliper Set
Hole Gage, 0.300 to 0.400 Inch
Hole Gage, 0.400 to 0.500 Inch
Spring Compression Tester
Materials:
None
Personnel Required:
Inspector
References:
Task 7-1.1
Equipment Condition:
Off Helicopter Task
Brake Transfer Valve Disassembled (Task 7-232)
NOTE
General inspection criteria (Task
7-1.1) for obvious damage applies
unless otherwise stated.
Inspection steps cover parts that are
subject to wear.
1.
Measure diameter of bore (1) in body (2).
Diameter shall not be more than 1.501 inch.
2.
Measure bore (3) and outside diameter of piston
(4). Bore shall not be more than 0.469 inch.
Outside diameter shall not be less than 1.497
inches.
7-876