TM 55-1520-240-23-6
7-190
DISASSEMBLE AND INSPECT TRANSFER CYLINDER (AVIM)
7-190
INITIAL SETUP
Applicable Configurations:
All
Tools:
Hydraulic Repairers Tool Kit, NSN 5180-00-323-4891
Deep Well Socket, 7/8 Inch
Adapter, 3/8 to 1/2 Inch
Container, 2 Quart
Soft Jawed Vise
Arbor Press
Aluminum Rod, 1/2 Inch X 12 Inch
Technical Inspection Tool Kit, NSN 5180-00-323-5114
Outside Micrometer Calipers, 1 to 2 Inch and 3 to 4
Inch
Telescoping Gage Set
Materials:
Cloths (E120)
Personnel Required:
Aircraft Pneudraulics Repairer
Inspector
References:
Task 7-1.1
Equipment Condition:
Off Helicopter Task
NOTE
General inspection criteria (Task
7-1.1) for obvious damage applies
unless otherwise stated.
Inspection steps cover parts that are
subject to wear.
1.
Install cylinder (1) in vise (2).
2.
Remove lockwire from cap (3) and cylinder (1).
3.
Remove cap (3). Use 7/8 inch deep well socket.
Use container and cloths (E120) for spilled fluid.
4.
Remove packing (4) from cap (3).
7-762