TM 55-1520-240-23-6
7-58
REMOVE NO. 1 OR NO. 2 POWER TRANSFER UNIT MODULE
(Continued)
7-58
NOTE
Procedure is same to remove No. 1 or
No. 2 power transfer module. No. 1
module is shown here.
NOTE
If a crack in the power transfer units
is suspected during removal, refer to
TM 1-1520-253-23.
1.
Tag and disconnect two tubes (1) from module
(2). Use tag (E264). Use cloths (E135) for spilled
fluid. Use gloves (E186).
2.
Tag and disconnect two tees (3) from module
(2). Use tag (E264). Use container and cloths
(E135) for spilled fluid.
3.
Tag and disconnect two tubes (4) from module
(2). Use tag (E264). Use cloths (E135) for spilled
fluid.
4.
Disconnect connector (5) from valve (6).
5.
Remove four bolts (7) and washers (8).
6.
Remove module (2).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
7-277