TM 55-1520-240-23-6
7-33
REMOVE NO. 1 OR NO. 2 POWER CONTROL MODULE FILTER ELEMENT
(Continued)
7-33
NOTE
There are four filter elements, two
in No. 1 and two in No. 2 module.
Procedure is same to remove any filter
element. No. 1 module is shown here.
NOTE
If diaphragm must be removed, refer
to (Task 7-349).
1.
Loosen nut (1).
2.
Turn fitting (2) to allow clearance for removal of
filter bowl (3).
3.
Disconnect connector (4) from switch (5).
Bowl contains hydraulic fluid. Do not
spill.
4.
Remove lockwire from filter bowl (3). Remove
filter bowl (3). Use cloths (E135) for spilled fluids.
Wear gloves (E184.1).
4.1.
Remove element removal spring (6) from filter
port (7) of module (8).
5.
Remove element (9) from filter bowl (3).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
7-184