TM 55-1520-240-23-6
7-300
INSTALL POWER STEERING ASSEMBLY
(Continued)
7-300
4.
Slide assembly (3) to outboard position as
shown.
Antiseize compound (E75) can form
toxic vapors if exposed to flame.
Use in well-ventilated area, away
from open flame. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
5.
Coat shanks of two bolts (7) with antiseize
compound (E75).
6.
Install two washers (8) and bolts (7).
7.
Install two washers (9) and nuts (10). Torque
nuts to 850 inch-pounds.
8.
Install washer (11) and nut (12) on stud (2).
9.
Tighten nut (12). Make sure washer (1) is free
to turn. Leave 0.002 inch maximum between
washer (1) and rod end (6). Do not install cotter
pin at this time.
10.
Install packing (14) and elbow (15) as shown.
11.
Install packing (17) and elbow (18) as shown.
7-1099