DISASSEMBLE DRIVE SHAFT
Remove six nuts (7), and washers (8) from
bearing retainer (9). Remove retainer.
Remove bearing support (4) from adapter
Do not put pressure on inner race of
bearing to remove bearing. Damage
to bearing can occur.
Remove two nuts (10), six washers (11) and
two bolts (12) from mount (13) on each side of
bearing support (4). Remove mounts.
Remove bearing (14) from bearing support
(4). If bearing does not remove easily, heat
support to 175ºF (80ºC). Use heat lamp. Monitor
temperature with temperature indicating strips
FOLLOW ON MAINTENANCE:
END OF TASK