REPLACE COMBINING TRANSMISSION MAIN OIL FILTER ELEMENT
INSTALL FILTER ELEMENT
Dry cleaning solvent (E162) is
flammable and toxic. It can irritate
skin and cause burns. Use only in
well-ventilated area, away from heat
and open flame. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
Clean inside of housing (3) with dry cleaning
solvent (E162) and cloths (E120). Check that
hole (11) is free of debris. Wear gloves (E186).
Hold housing (3) with indicating button (12) up.
Push down button until it locks.
Do not reuse removed element.
Install new element (9) in housing (3).
Install gasket seal (10) and housing (3) on four
studs (13). Install four washers (2) and nuts (1).
Torque nuts to 60 inch-pounds.
Service combining transmission (Task 1-54).
Close aft pylon doors (Task 2-2).
END OF TASK