INSTALL HYDRAULIC PUMP DRIVE SHAFT SEAL ON AFT TRANSMISSION
Dry cleaning solvent (E162) is
flammable and toxic. It can irritate
skin and cause burns. Use only in
well-ventilated area, away from heat
and open flame. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
Install pump drive shaft seal on left
or right side of transmission in same
way. Right side shown here.
Clean seal seating area of transmission (1) and
packing groove (2). Use dry cleaning solvent
(E162) and clean cloths (E120). Wear gloves
Wear Kevlar gloves when working
around heated area. Hot metal can
Do not heat transmission over 250ºF
(120ºC). Metal can be damaged.
Heat seal seating area (1) to 230º to 250ºF
(110º to 120ºC). Use gun-type heater. Wear
Kevlar gloves (E187). Check temperature with
Oil (E254) is toxic. It can irritate skin
and cause burns. Avoid inhaling. Use
only with adequate ventilation. Avoid
contact with skin, eyes, or clothing.
In case of contact, immediately flush
skin or eyes for at least 15 minutes.
Get medical attention for eyes.
Coat packing (3) with oil (E254). Install packing
in groove (2).
Coat lip of seal (4) and sealing surface of drive
shaft (5) with oil (E254). Install seal or drive shaft,
flat side out. Use aluminum tube to seat seal.
Install retaining ring (6).