INSTALL COMBINING TRANSMISSION OIL COOLER FAN DRIVE SHAFT
Oil (E254) is toxic. It can irritate skin
and cause burns. Avoid inhaling. Use
only with adequate ventilation. Avoid
contact with skin, eyes, or clothing.
In case of contact, immediately flush
skin or eyes for at least 15 minutes.
Get medical attention for eyes.
Coat packing (5) with oil (E254). Install packing
(5) on retainer (1).
Apply light coat of grease (E190) to lip of seal
(3). Apply light coat of oil (E254) to surface of
shaft (6). Install retainer (1) on four studs (7).
Install four washers (8) and nuts (9) on studs (7).
Torque nuts to 60 inch-pounds.
Install snubber (10) on end of shaft (6).
Install oil cooler fan and drive shaft (Task 6-186).
Close cargo ramp (Task 2-2).
END OF TASK