TM 55-1520-240-23-5
6-30.3
INSPECT ONE-PIECE ENGINE DRIVE SHAFT (REMOVED)
(Continued)
6-30.3
NOTE
One nut and bolt assembly (removed
during shaft removal) will be loosely
installed on each adapter assembly.
5.
Check torque on two torqued nuts (10) at each
adapter assembly (7 and 8). Torque shall be at
least 440 inch-pounds.
a.
If torque is less than 440 inch-pounds at any
of the checked locations, replace that adapter
assembly and attaching hardware.
b.
If a nut or bolt fails during the torque check,
replace the adapter assembly and attaching
hardware.
FOLLOW-ON MAINTENANCE:
None
END OF TASK
6-94