• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
REPAIR COMPOSITE WEATHER-PROTECTIVE  COVER  (AVIM) (Continued) - TM-55-1520-240-23-4_788
REPAIR COMPOSITE WEATHER-PROTECTIVE  COVER  (AVIM) (Continued) - TM-55-1520-240-23-4_790

TM-55-1520-240-23-4 CH-47D Heilcopter Manual
Page Navigation
  758    759    760    761    762  763  764    765    766    767    768  
TM  55-1520-240-23-4 5-137.1 REPAIR  COMPOSITE WEATHER-PROTECTIVE COVER  (AVIM) (Continued) 5-137.1 PUNCTURE  THROUGH  ONE SKIN AND  CORE  (TO 1 SQUARE-INCH) 59. Outline  area  of  puncture  (20) with  circle  or oblong.  Use  pencil  compass and  straightedge. 60. Remove  finish  down  to  primer  from  an  area 1.5 inches larger in  all  directions  than  outline around  puncture  (20).  Use  abrasive  paper  (E8). Use  cloths  (E120)  damp  with  acetone  (E20)  as needed  to  soften  finish.  Wear gloves  (E186). 61. Prepare  mixture  of  adhesive.   (Refer to  steps 106  thru  109.)  Fill  puncture  (20)  with  adhesive mixture  to  surface  of  cover  (1). Do  not heat  cover surface  over 160ºF (71ºC).  Higher  temperatures  can damage  cover. 62. Cure  adhesive  at  140º  - 160ºF (60º  - 71ºC)  for 2 hours.  Use  heat lamp.  Monitor temperature  with temperature  indicating  strips (E413). NOTE Serviceable  cure  can  be  achieved without heat  at  70º  - 80ºF (21º  - 27ºC) in 24 hours. 63. Fair  cured  adhesive  to  surface  of  cover  (1).  Use abrasive  paper  (E9). 64. Clean  area  of finish  removal.   Use  clean  cloth (E120)  damp  with  acetone  (E20).   Wipe  area dry with  clean  dry cloth.   Repeat  until  there  is no  residue  on  dry  cloth. 5-763







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.