5-126.1.1 REPLACE SWASHPLATE LOWER SEAL (AVIM) (Continued)
INSTALL LOWER SEAL
Dry cleaning solvent (E162) is
flammable and toxic. It can irritate
skin and cause burns. Use only in
well-ventilated areas, away from heat
and open flame. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
Clean mating surfaces of seal (11), retainer (9),
and rotating ring (4). Use dry cleaning solvent
(E162) and clean cloths (E120). Wear gloves
(E184.1). Allow solvent to dry.
Wear Kevlar gloves (E187) when
handling heated parts.
Heat retainer (9) to 170° - 190°F (77° - 88°C).
Use an oven.
Install seal (11) in retainer (9). Use a phenolic
drift and mallet.
If seal distorts while tightening,
straighten the seal by tapping down
using a phenolic drift and hammer.
Install grease seal (10) and lower seal retainer
(9), with seal (11) installed in rotating ring
assembly (4). Install bolts (8), washers (7 and
6), and nuts (5).
Do not re-use any nut (5) after it has
been installed once.
Progressively tighten nuts (5). Do not apply full
torque to any one nut until all nuts are ready for
Tighten nuts (5) evenly to 350 inch-pounds
above friction torque.
5-704 Change 1