• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL SHOCK ABSORBER (Continued) CONNECT SHOCK ABSORBER  AT INBOARD LUGS
INSTALL SHOCK  ABSORBER (Continued)

TM-55-1520-240-23-4 CH-47D Heilcopter Manual
Page Navigation
  553    554    555    556    557  558  559    560    561    562    563  
TM  55-1520-240-23-4 5-93 INSTALL  SHOCK  ABSORBER (Continued) 5-93 CONNECT  SHOCK  ABSORBER  AT  OUTBOARD LUGS 8. Check  that  bushing  (15)  is  installed  in  lower  lug (16). NOTE Positive  retention  bolts  are  installed  in shock  absorber  bearings.  These  bolts require  special torque  (Task  1-14). 8.1. Coat  bushings  (15  and  15.1)  with  a  very  light coat  of  antiseize  compound  (E75). Antiseize  compound  on  thread  of  bolt or  nut  may  result  on  over-torquing. 9. Install  rod-end  bearing  (17)  between  outboard lugs  (16  and  18).  Align holes  in  lugs  and  bearing. Install  bolt  (4). NOTE A  gap  between  top  of  bracket  (18)  and flange  of  bushing  (15.1)  is  allowed. Bushing  may  contact  bolt  head. 9.1. Check  that  there  is  no  antiseize  compound  on thread  of  nut  (19). 10. Install  nut  (19).   Torque  nut  to  60  to  100 foot-pounds.  Install  cotter  pin  (20). 5-562







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.