• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
PREPARE  ADHESIVES
REFINISHING  ROTARY-WING  BLADE (Continued)

TM-55-1520-240-23-4 CH-47D Heilcopter Manual
Page Navigation
  480    481    482    483    484  485  486    487    488    489    490  
TM  55-1520-240-23-4 5-82 REFINISHING  ROTARY-WING BLADE 5-82 INITIAL  SETUP Applicable Configurations: All Tools: Sanding  Block Materials: Gloves  (E184.1) Abrasive  Paper  (E7) Acetone  (E20) Abrasive  Paper  (E9) Aliphatic  Naphtha  (E245) Cloth  (E120) Antistatic  Coating  (E135.5) Black  Lacquer  (E215) Thinner  (E415) Personnel  Required: Aircraft  Structural  Repairer Inspector Equipment  Condition: Off  Helicopter  Task References: TM  55-1500-344-23 Task  2-350.1 1. Determine  the  finish  system  used  on  the  rotor blade  (TM  55-1500-344-23). a. For rotor blades without   59   proceed  to  step 1.1. b. For rotor  blades  with    59    proceed  to  Task 2-350.1. 1.1. Remove  finish  around  repaired  area  of  blade  (1) as  follows: a. Remove  finish.   Use  sanding  block  and abrasive  paper  (E7). Acetone (E20) is extremely flammable. It  can  be  toxic.   Avoid  inhaling.   Use only with  adequate  ventilation.  Avoid contact  with  skin,  eyes,  or  clothing. Keep  away from  heat, sparks,  or open flame.  In  case  of  contact, immediately flush  skin  or  eyes  with  water for at  least  15  minutes.   Get  medical attention  for  eyes. b. If  finish  requires  softening,  use  acetone (E20).   Wear gloves (E184.1). c. Complete  finish  removal.  Use  abrasive  paper (E9). 5-489







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.