TM 55-1520-240-23-4
5-74
INSTALL BLADE TIP COVER
(Continued)
5-74
If end caps (6) are recessed more
than 0.06 inch, tip cover (1) will not
be property retained.
2.
Check end caps (6) are flush with end of weight
tubes. If any end cap is recessed more than
0.06 inch, replace blade balance weight spacers
(Task 5-82.1, steps 6 thru 9).
3.
Position tip cover (1) on blade (7). Install four
screws (8) and washers (9). Torque screws to
175 inch-pounds.
4.
Lockwire screws (8). Use lockwire (E233).
INSPECT
FOLLOW-ON MAINTENANCE:
Close work platforms (Task 2-2).
END OF TASK
5-422